Portable Oil Ferrous Debris Tester is an important method for early warning and avoiding mechanical failures. It can detect worn parts at an early stage of wear, and serious losses can be avoided by replacing them. Existing abrasive particle monitoring methods all have some defects and deficiencies. For example, oil spectrometer is limited by carrying capacity and excitation energy, and cannot quantitatively monitor particles larger than 5 µm; the measurement results of ferrography are only relative coefficients rather than absolute concentrations. The use of the iron meter can directly measure the concentration of all ferromagnetic abrasive particles in the oil sample without processing the oil sample. The iron meter can analyze the content of iron abrasive particles in various samples of mineral oil, synthetic oil, hydraulic oil, gear oil and lubricating grease.
A: Detection hole, during calibration and measurement, the oil sample test tube is put into this hole
B: LCD screen
C: reset button
D: check key
E: “Working” status indicator light
F: “Calibration” indicator light
Features of Portable Ferrous Debris Tester ASTM D8120
1. Adopt patented sensor and signal processing circuit, with good stability, high sensitivity and resolution up to ppm level.
2. Oil sample transmission and measurement are carried out automatically, and one data can be measured in 10 seconds.
3. The oil sample does not need to be processed and can be directly injected into the oil bottle for measurement.
4. English and graphical interface, user-friendly operation.
Instrument parameters:
Power supply: AC220V±15%, 50-60Hz
Ambient temperature: 0℃～50℃
Storage temperature: -20℃～80℃
Working humidity: 20%-80% relative humidity
Storage humidity: 0%-95% relative humidity
Iron filing size: more than 1 micron
Maximum concentration range: 0-5500mg/L
Measurement sensitivity: down to 1 mg/L
Sample volume: 2ml each time
Power consumption: <100W
Product size: length X width X height (158mm*150mm*88mm)
Weight: 1500g